yOn Wed, 12 Jul 2000, Matthew Maschmann wrote:
On Wed, 12 Jul 2000, Robb Kambic wrote:
> On Wed, 12 Jul 2000, Matthew Maschmann wrote:
>
> > Robb,
> >
> > Thank you for the reply. I have since moved on past the
> > netcdf-perl problem, but my decoders still do not work. I have included
> > my log file for "make test" as test.log and from test.pl as testpl.log.
> >
> > Thanks for your help,
> > Matt
> >
> >
> Matt,
>
> I not sure about your problem. For sanity sake, have you installed
> netCDF and built the netecdf-perl code? Where is the netCDF.pm module
> located?
Yes, netcdf and netcdf-perl are both installed.
NetCDF.pm is located under/netcdf-perl-1.2/src/perl/NetCDF.pm
>
> Can you cd to the metar dir in the decoders source tree and run the
> following:
>
> % metar2nc metar.cdl 0002 < testdata.wmo
>
Matt,
The log file suggests that ncgen was never called to create the netCDF
file, so the decoder doesn't have a destination file to write to. ie
ncopen: filename "./00021707_metar.nc": No such file or directory
Look in the current dir for the file, if it not there try:
% ncgen -o 00021707_metar.nc metar.cdl
Usually the decoder checks for ncgen before it even starts to run. Do you
have write permission in the metar dir?
If ncgen created 00021707_metar.nc, then try:
% ncdump 00021707_metar.nc | more
Try running the metar2nc again. Also what type of machine/OS and version
of perl are you running?
Robb...
The log file is attached
>
> This should complete ok, if not send me the metarLog.????.log file, it
> should have the problem listed.
>
> Robb...
Thanks,
Matt
==============================================================================
Robb Kambic Unidata Program Center
Software Engineer III Univ. Corp for Atmospheric Research
rkambic@xxxxxxxxxxxxxxxx WWW: http://www.unidata.ucar.edu/
==============================================================================
